Features of the floating isothermal cover model Geobubble EnergyGuard by AstralPool
Its composition is polyethylene-based.
Thanks to the bubble, which is 50% thicker compared to the traditional one, a limited space is created for air expansion. It features a smooth shape with uniform thickness.
It features sharp corners and fine points.
Full protection against chemical and UV attacks by rays coming from the sun.
It features an ultrasonic welded joint.
The edges are stitched by polyethylene piping.
The fastening is by means of:
- Eyelets at each end on the first side of the width.
- Eyelets home 65 cm. approximately on the second side of the width.
It is composed of nickel-plated brass eyelets.
Supplied in cardboard box with protective sleeve and instruction manual.
Thickness of 500 μm.
Finish types:
- Borderless model. It only presents cut, it has neither edging nor eyelets and does not allow the use of a winder.
- Model DUO. Features polyethylene piping, which is stitched on both width sides. Brass eyelets appear on one side every 65 cm on one side. Features two brass eyelets on the ends of the other side.
- Luxe model. Features polyethylene perimeter piping that is stitched. Brass eyelets appear on one side every 65 cm. on one side. Features two brass grommets on the ends of the other side.
Minimum purchase of 10 square meters.
Any Non-Standard shape that requires a template for its manufacture will be considered a FREE SHAPE.
for the shapes you need to take the correct measurements in order to adapt it to the established templates.
For this, describe the shape of the vessel in a rectangle; L is the length and I is the height. Area= L x I
In case the vessel is a free form, and the standard templates cannot be applied, an extra amount will be applied.
The templates must be factory checked and with perfectly visible strokes to avoid any possible error.