Features of the AstralPool
Its composition is polyethylene-based.
It is joined by ultrasonic welding.
The edges are sewn by polyethylene piping.
The fastening is by means of:
- Eyelets at each end on the first side of the width.
- Eyelets home 65 cm. approximately on the second side of the width.
It is composed of nickel-plated brass eyelets.
It is supplied in cardboard box with protective cover and instruction manual.
Thickness of 400 μm.
Finishing types:
-Model NB. It only presents cut, it has neither trimming nor eyelets and does not allow the use of a winder.
- ECO model. It features polyethylene piping, which is sewn on both width sides. Brass eyelets appear on one side every 65 cm on one side. Features two brass eyelets on the ends of the other side.- Model Luxe. Features sewn polyethylene perimeter trim. Brass eyelets appear on one side every 65 cm. on one side. Features two brass grommets on the ends of the other side.
- Model ONE. Features polyethylene piping sewn on one side of the width. Brass eyelets every 65 cm.
Minimum purchase of 10 square meters.
Any Non-Standard shape that requires a template for its manufacture will be considered a FREE SHAPE.
For the shapes you need to take the correct measurements in order to adapt it to the established templates.
For this, describe the shape of the glass in a rectangle; L is the length and I is the height. Surface= L x I
In case the vessel is a free form, and the standard templates cannot be applied, an extra charge will be applied.
The templates must be checked by the factory and with the lines perfectly visible in order to avoid any possible error.
/p>